650 Series – Bullet Resistant
650 Series Bullet Resistant 5 & 7 – Ply
Hardwood Veneer / MDO / HDF or High Pressure Decorative Laminate (HPDL)
WDMA/AWS: BR – Special Function Doors
Door sizes: (Non rated) 1-3/4” – 2-1/4” thick, up to 4’ wide x 8’ high (Check with sales for larger doors).
Warranty: Lifetime for interior use only. See Vancouver Door Warranty.
Blocking Options: For undercutting and specialized hardware. Must be specified if required. See “Blocking Adds” page
Available rating options for 650
- Standard construction = STC 37.
- Lites – Recommended glazing systems must be used to obtain the maximum STC rating which may conflict with fire rating requirements.
Currently not tested or approved for pairs. Pairs or doors with transoms may require additional sealing / gasketing systems.
See the STC Transmission Information.
- MR 4.1 – Recycled Content: 10%
- MR 4.2 – Recycled Content: 20%
- EQ 4.4 – Low Emitting Materials – No Added Urea Formaldehyde (NAUF)
- Low VOC’ s on all finishes.
- All products conform to “CARB” Phase II requirements.
See our “LEED” Matrix for additional information.
*Note: Each STC rated door requires a specific sealing system to maintain the rating. We can supply a complete system or you may supply as long as the system conforms to the test data. Check with our technical department.
Sized, beveled & machined for just about any specified surface, mortised or electrified hardware and Prefinished.
These doors are specifically designed to protect occupants
from potential threats from fire- arms, specifically handguns rang- ing from small caliber up to .44 caliber. You will typically find the need for these doors in applications such as court houses, deten- tion facilities, schools, safe rooms and safe havens or any area where the need for security is of priority.
The doors overall quality and appearance is identical to any other of our product lines with the exception of the inner construction. These doors are manufactured in compliance to meet and/or exceed the standards for UL 752 Level 3 classification.
Applied moldings, quirks, inlays, sketch face and most hardware preparation.